8L Double Action Electric Hydraulic Pump High Pressure Tank
capacity hydraulic Motor Oil pump
|Working pressure||high pressure:70Mpa||low pressure:7Mpa|
|Rated output||high pressure:0.9L/min||low pressure:5L/min|
|Working Power||50-HZ / 220V(Customizable, price add 35 USD)|
|Oil Capacity||7L(Customizable.)||Type of oil||15#-46# antiwear hydraulic oil|
1. The pump can be used as a hydraulic pump for various hydraulic
2. After the pump and other hydraulic tools are equipped, it can
carry out many tasks such as lifting, pressing, bending, bending,
straightening, shearing, assembly and disassembly. Reduce labor
intensity and improve work efficiency.
Method of use
When using, open the bleed nut, open the switch on the oil
collecting block, plug in the power supply, and put the quick
connector on the quick head on the hydraulic device. Press the
power switch, wait for the motor to rotate for 1-2 minutes, and
turn the switch off to the boost state. At this time, the output
hydraulic oil will perform various work, and the output hydraulic
oil will pressurize itself with the increase of the load to carry
out various work until 70MPA. .
After the work is finished, open the switch to unload. After the
hydraulic oil is returned to the oil, remove the quick joint
sleeve, screw the bleed nut, remove the electric screw, and close
- 1. The oil pump uses No. 7 hydraulic oil (mechanical oil) oil
requirements: the thinner the better.
- 2. The oil storage capacity must be within the upper range of the
- 3. When refueling and oil change, it must be filtered with oil
filter mesh of more than 80 mesh. When replacing, you need to clean
the fuel tank. The oil change period is six months.
- 4. Working oil temperature is 10 degrees Celsius to 50 degrees
- 5. Open the bleed nut before starting the electric pump and open
the switch to the unloading position.
- 6. If the motor temperature is too high during use, it should be
stopped. Allow to cool before use.
- 7. The pump has been adjusted before leaving the factory. It should
not be adjusted at will. If it needs to be re-adjusted, it must be
done with a pressure gauge.
- 8. The high pressure oil pipe is delivered to the factory and
passed the 105MPA test. However, because the hose is easy to age,
the user should check it frequently, usually for six months. It is
frequently used for three months. When it is inspected, it can be
used for 87.5MPA. If it is damaged, raised or leaked, it cannot be
- 9. The bearing is usually cleaned once every six months, and grease
should be added during assembly.